Activation code and software installer securely stored online in your private MY ACCOUNT associated with your purchase.
INCLUDES: Downloadable Sep Studio NXT software license (Mac and Windows).INCLUDES: Downloadable AccuRIP Emerald software license (Mac and Windows).Removing the tanks to refill outside of the printer then inserting them will allow the chips on the tanks to reset! REFILL TANKS WHILE OUTSIDE OF THE PRINTER. Using the provided syringe top off all tanks. Poor results of an ink and film mismatch include slow drying, inconsistent results, a haze around the print that happens as water separates the emulsion from the carrier sheet.Īt the first sign of a light print check the tanks to see if they need additional dye added. Dye is recommended for printing films for screen exposure. This otherwise fine brand is NOT coated for best results with DYE like Dmax Ink™. Unapproved Film Brands: Ulano PIJF (Pigment Inkjet Film). Look for film that works with DYE ink when using the Dmax™ Dye in your Ink Master Kit. With a variety of film manufacturers with different manufacturing specifications some will work best, work better than others, or not work well at all. If necessary run a cleaning routine.Ī clean Nozzle Pattern test print means you are ready to start printing films. Open the printer’s OEM driver and run a Nozzle Pattern test print to verify the printer is clean and BLACK ink is properly printing.
Load a few sheets of plain letter size paper into the printer. Refer to your AccuRIP™ Emerald documentation.
Make sure that the All Black Ink™ feature is ON so all slots are being used during printing. Install and setup AccuRIP™ Emerald Software by Freehand. Close printer lid (cover), plug the power cord into printer. Insert filled tanks into the proper slots. Slots in the print head are labeled with coordinating colors. With the print head centered and not moving remove the power plug from back of printer. DO NOT PEEL OFF THE PLASTIC INK SEAL (where the ink flows out of cartridge)! Only the yellow tabs that say remove should be removed. Fit plugs snug enough to prevent dye ink from splashing out during transport or installation. (d) Plug each fill hole with provided rubber “L” shaped plugs. Inject ink slow enough to avoid a spillover. (c) Insert syringe deep, but not to tank bottom. (b) Wearing gloves fill the syringe with Dmax™ Black Dye. This is the ONLY part of the tank that needs to be removed/peeled off. (a) Remove yellow air hole tabs on all 6 tanks. Contact Epson directly if printer is not printing and/or producing a clean test print from the Epson Printer Driver. Setup your Epson printer using stock Epson inks.